EmeraldFloc C20

Cationic
Medium-Low Charge
High MW

EmeraldFloc™ C20

A medium-low-charge cationic grade for sludge thickening and industrial effluent, where mineral or mixed solids dominate.

Where it works best

Recommended applications for EmeraldFloc™ C20. Not sure it fits your process? We will confirm the grade with a jar test on your own sample.

Technical data

Product type
Cationic polyacrylamide flocculant
Appearance
White to off-white granular powder
Ionic charge
Cationic, medium-low (approx. 15–25 %)
Molecular weight
High (approx. 8–10 million Da)
Active solids
≥ 88 %
Bulk density
0.65–0.80 g/cm³
Working pH
Acidic to neutral (approx. 3–9)
Packaging
25 kg bags; other sizes on request
Shelf life
24 months, unopened, cool and dry
Typical values for guidance only, not a specification. Full technical data sheet and safety data sheet available on request.

Dosing & handling

1. Prepare

Disperse the powder into water at 0.1–0.5 % with gentle mixing (below about 300 rpm) to avoid lumps and chain damage.

2. Age

Allow 30–60 minutes to dissolve fully, then dilute to about 0.025–0.1 % at the dosing point. Use the solution fresh.

3. Dose

Typical starting range: 3–8 kg/t of dry solids for sludge dewatering. Fine-tune with a jar test on your own sludge.

4. Store

Keep bags sealed, cool and dry. Spilled powder is very slippery when wet, so sweep up dry.

Not sure C20 is the right grade?

Tell us about your slurry or sludge. We will recommend a grade and can arrange jar testing and a sample.

Get in Touch

Our team is ready to support your flocculant and polymer requirements.

Get in Touch

Our team is ready to support your flocculant and polymer requirements.

© 2026 Emerald Chemicals. All rights reserved.